Can’t get insta D to show fault codes

[Wmbbmw1977e70x5black]

Hi all

downloaded the insta d latest version and installed it ok, I’ve put my vin in and shows me all the info but the tree box isn’t letting me click on it to show faults , using a d kcan cable with a switch on it, not sure where the switch is supposed to be on

any help thanks bmw 2011 40d e70

[Greydog]

Hi again Aaron

I think you need the E-net cable (Yellow one) to communicate properly with your car 

Dave

[Wmbbmw1977e70x5black]

I’m using a normal usb one for insta d, just want to clear codes 

[Wmbbmw1977e70x5black]

This is now what it shows after changing the file to OBD in c drive 

Maldonado changed the settings in ista d

[Greydog]

Hi Aaron

I use ISTA/INPA The d+can cable works up to around 2006/7 models for anything later I use the E+net cable never had an issue

Dave

[Wmbbmw1977e70x5black]

Hi, don’t think my laptop has a slot for the cable to plug into, 

[Greydog]

Just talked to a friend who sent me this 

USING ISTA WITH USB K+D-CAN CABLE (Example using Com Port 9) Plug your K+D-CAN cable and install drivers. For FTDI based cables use latest drivers. Open “Device Manager”, then USB Serial Port properties, go to “Port Settings” tab and click “Advanced...”. Change port number to “COM9” and latency timer to “1”. Confirm configuration via “OK” button.

[Wmbbmw1977e70x5black]

Ok will try later thanks