Jump to content

Denkmal

Regular Member
  • Posts

    8
  • Joined

  • Last visited

Profile Information

  • First Name
    David
  • BMW Model
    Z3 1.8
  • BMW Year
    2021

Denkmal's Achievements

Rookie

Rookie (2/14)

  • Week One Done
  • First Post
  • Conversation Starter

Recent Badges

0

Reputation

  1. Finally found the problem can low at the ASC sensor wire had corroded through just before the multiplug. Found it by finally following the diagram and continuity checks. It wasn't as obvious as it looks in the photo as the insulation was covering it, just a speck of green I noticed after putting on two pairs of glasses. Thanks for your replies. Dave
  2. Dave thanks, I'll dig into it later when my brain fog lifts. Dave
  3. Yes seems that way, I prized open the abs sensor and I couldn't see any obvious signs but I re -soldered the plug terminals as a precaution. Still waiting for a decent wiring diagram before delving further, but thanks for the help. Dave
  4. I've taken both seats out , removed plastic covers over both sides of the harness's, pulled back the mats and checked all cavities. There definitely are no sensors anywhere. I've checked the realoem using the Vin and I can't find any mention of the sensor.
  5. Forgot to mention ABS as standard no parts changed and no warning light showing.
  6. Dave thanks for replying. I had a closer look at some wiring diagrams last night but they are all slightly different wiring on the ABS module from the one that's fitted. I have sent to Canada for a better diagram and hopefully this vehicles in it. It seems however some of the early builds don't show a Yaw sensor so I presume this car first reg Mar 2001 was probably a 2000 build. I will check the link you sent me and I'll post what , if ever I do find, the result.
  7. Hi my grandson has a Z3 1.8 Roadster reg Mar 2001. I apologise for posting what must be the most recurring query but I can't find the answer anywhere. The car has the ASC light on and scanning comes up with ASC bus cam fault. I've found the can resistance is 120ohms and checking the ABS sensor I read 120 at the pins. So my next check apart from cam high low voltage was to locate the Yaw sensor to check the resistance there, but for the life of me I cannot find the sensor under in front or behind , or on the side of both seats. I also looked behind the centre console . Am I going mad or is there another location.Help would be much appreciated.
×
×
  • Create New...

Forums


News


Membership