-
Latest Topics
-
1
Refitting N47 crankshaft pulley/damper
Hi Oliver There are many bolts that require Torq plus a Degree tightening sequence so best to stick to the sequence or you could over stretch the bolts and end up with them failing I have a 1/2" drive degree tool but you can cut a circle of cardboard and mark 0, 90, 180, 270 off in pen then mark 3 equal sections in each segment. Torque to 40Nm then put your card in place mark the 0 point on the car with tippex. Now you can turn the bolt 90 plus one segment (30d) for your 120d, always tighten in a diagonal pattern Dave -
1
Refitting N47 crankshaft pulley/damper
On refitting the crankshaft pulley it says torque up the 4 Torx bolts to 40Nm and 120deg. Can a larger torque value be used and if so does anybody know what it would be -
1
316D DPF F31 type filter replacement
Morning Tony Welcome to the Forum First start with a search for the correct part number for your car use www.realoem.com (if you are not aware it is an online BMW parts list) put the last 7 digits of your Vin into the search box it will bring up your model, then search the Exhaust section (is your car EU3, EU5, EU6) Once you have the correct part number use it to find the best supplier/price (£300 to £400) would be my expectation remember you may have to add clamps and gaskets to the price. If the part is correct fitting should be straight forward it will however need setting up. Depending on labour cost I would guess the whole job to be £800 to £1000 depending on what additional parts are needed Remember you can't just bolt it on, the ECU has to be set up to know the car has a new DPF (your garage should know that) Also make sure the Glow plugs and Controller are working correctly or the Regen cycle wont work correctly. Hope that helps Dave -
1
316D DPF F31 type filter replacement
Got a duff DPF filter on my 316D touring my mech says that apart from it being blocked its not regenerating! also its now broken at the exhaust output which is causing the exhaust pipe to wiggle around a bit and he a says we need a replacment one as it can't be welded as such. I don't doubt what he says its just the replacment one, seems new ones are around a grand or more but a wide range on ebay and quite a few suppliers from Germany like Autodoc.. Now not suprising seeing their German suppliers but in recent times he's had a lot of greif with spare parts from most all motor factors and the like i've seen some of the problems he had had with other cars like a clutch place that just didnt work! another suppliers did!, turbo for a range rover would spin and then stop something inside jammed up so what apart from the BMW new one anyone recommed a decent supplier either ebay or a breaker or a German supplier?. Car is fine otherwise its 2102 vintage done around 136,000 miles?. Thanks for any advice.. -
4
Mobile charging tray not working
Hi Paul, Out of interest does you wireless charge tray actually charge your phone? Or does it just turn it into a small heater that get hotter than the sun, causing the phone to shut down due to overheat and put a very small amout of charge in it as mine does?
-
-
Recent Achievements
-
Recommended Posts
BMW Official Store
Sponsored Ad
Name: eBay
BMW Model: BMW Store
BMW Year: 2024
Latest Deals
BMW Official Store for genuine BMW parts & accessoriesDisclaimer: As the club is an eBay Partner, The club may be compensated if you make a purchase via eBay links
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.